Barrel Installation; Now that you’ve gotten through the most difficult part & the end is near, we’re going to install the barrel assembly(which has already been headspaced). The barrel installation attachment threaded in 14×1 left hand to match your barrel, needs to be threaded completely to the barrel. Make sure the barrel goes into the trunnion evenly & straight. With the receiver firmly secured in a way that the force of your blows isn’t impacting the structure of the receiver or rails. Alignment of the pin hole on the barrel and trunnion, which has already been set, must be perfect to a degree that is hard to see with the naked eye, we’ve included headspace gauges to check it yourself.
Tools Used We Provide:
Threaded Barrel Installation Nut
Rivet Backing Anvil
Headspace Gauges (Go & No Go)
Tools Needed Not Provided: